Quickstart¶
Follow these steps to prepare ReJoySpot for a first stage setup.
- Install and open ReJoySpot on your iPad. Allow camera access when prompted; the camera is used to calibrate the stage view.
- Install and aim your fixtures. See Rig installation for installation guidance.
- Add fixture profiles in Settings > Fixtures. Configure each fixture's profile and DMX patch to match your equipment.
- Create or select a Show in Settings > Shows. Set the stage dimensions and configure the rig for that Show.
- Calibrate the stage view with the iPad camera. Match the four calibration handles to the corresponding corners of the stage floor. Keep the iPad in a fixed position; recalibrate if the camera moves.
- Configure DMX output in the Show's DMX Output settings. Choose Art-Net or sACN, enter the receiver address and protocol settings, then enable output when the rig is ready.
- Test the aim and output with the fixtures pointed safely at the stage. Move the aim and confirm the beams land where expected.
For descriptions of app terms, see the Glossary. For the controller's available options, see Settings.